We answer 24/7
Gilbert Mold Removal, From the Leak to the Rebuilt Wall
Our base is on South Ramona Street in south Gilbert. When a slow leak behind a shower, a laundry line or a water heater has turned into a musty wall, we find the water, take out the moldy materials, dry the framing and put the room back together.
Request Service
Tell us what happened and we'll call you back. In a hurry? Call (623) 288-5596.
- We answer 24/7
Gilbert, AZ
Who handles mold removal in Gilbert?
Tri Point Services, from our base at 4218 S Ramona Street in south Gilbert, about nine road miles from the Municipal Center on Civic Center Drive. We find the water feeding the growth, close off the work area, remove moldy drywall, insulation or flooring, dry the framing, then rebuild as a licensed Arizona contractor (ROC 335008).
By its housing, Gilbert is a young town. The Census Bureau’s latest five-year estimates put the median home’s construction year at 2003, and only about 4% of the town’s 100,336 homes went up before 1980. Six in ten were built between 1990 and 2009, and about 73% of occupied homes are lived in by their owners. A newer house still grows mold when water sits inside a wall or under a floor. Gilbert’s 2025 drinking water report averaged 10.79 grains per gallon of hardness, so softeners, water heaters and the supply lines under sinks carry a steady load of minerals. Our mold remediation work starts here, a short drive from any Gilbert ZIP code.
Housing: U.S. Census ACS 5-year estimates. Distance is approximate road miles.
About Gilbert
Where does water collect in Gilbert?
Mostly on the east side of railroad and canal embankments. The town’s flood zone page says Gilbert slopes from east to west, so heavy rain backs up against those banks, and washes and low spots fill fast. FEMA maps dozens of shallow-ponding Zone AH areas in town, and Freestone and Crossroads Parks double as retention basins.
Most of the heavy rain arrives in the monsoon, which NWS Phoenix counts from June 15 to September 30. On September 8, 2014, Phoenix Sky Harbor logged 3.30 inches, its wettest calendar day on record, and the Weather Service’s summary of that storm shows flooding near Val Vista Drive and Germann Road. The county flood control district reported record flows that morning in the East Maricopa Floodway through Mesa and Gilbert. Later storm reports logged water backing up into yards south of Higley in August 2018, a Loop 202 exit ramp at Gilbert Road closed by flooding in August 2021, US-60 shut at Val Vista in July 2022, and a tree that fell partly onto a northwest Gilbert roof on August 12, 2026.
Mold follows the water, and the window is short. EPA’s guide to mold and moisture says wet materials dried 24 to 48 hours after a leak usually won’t grow mold, and it suggests keeping indoor humidity under 60 percent. It also warns against painting or caulking over moldy surfaces, because the paint is likely to peel. Hidden leaks tend to announce themselves as a musty closet, a stain that keeps spreading or a baseboard gone soft. Gilbert’s water reaches homes through SRP and CAP canals and two treatment plants, with groundwater added when demand peaks, over more than 1,500 miles of town pipe.
Gilbert covers ZIP codes 85233, 85234, 85295, 85296, 85297 and 85298, from the Heritage District downtown, with its color-changing water tower, out to Agritopia, Val Vista Lakes, the Islands, Power Ranch, Seville, Morrison Ranch, Lyon’s Gate, Cooley Station and Finley Farms. The Santan Freeway (Loop 202) carries most freeway traffic, and US-60 clips the north edge at Higley Road. Gilbert sits at Class 6 in FEMA’s Community Rating System, which raised the flood insurance discount inside the high-risk zone to 20 percent on October 1, 2024; check a parcel with Gilbert’s flood zone tools.
Permits & rebuilding
Does fixing a Gilbert home after a leak need a permit?
It depends on what gets rebuilt. Gilbert’s amendments to the 2018 residential code exempt water softeners, same-opening windows, re-roofs without structural change and like-for-like tank water heaters installed by an Arizona licensed contractor. Wiring, plumbing and framing aren’t on that list, and rough plumbing and electrical must be inspected before walls close.
Before the walls close up in a Gilbert house
- Call Gilbert Development Services at (480) 503-6700 or email onestopshop@gilbertaz.gov. The One Stop Shop works out of 90 E. Civic Center Drive.
- Plan around the rough inspection. Gilbert’s code amendments require plumbing, gas, mechanical and electrical rough work to be inspected before it is covered, so new drywall waits for that sign-off.
- If the lot sits in a FEMA flood zone, the town’s floodplain ordinance (Chapter 34 of the Code of Gilbert) applies to the work. Gilbert’s floodplain staff answer questions at (480) 503-6815.
- Read your HOA’s design rules before changing windows, roofing or exterior paint. Gilbert’s list of registered HOAs runs two pages, and state law says architectural approval can’t be unreasonably withheld.
- Keep our photos, moisture readings and job notes in one folder for the claim. We document the damage and talk with your adjuster; what the policy pays for is your insurer’s call.
Services in Gilbert
What can Tri Point fix in a Gilbert home?
Mold behind a wall after a slow leak, a laundry line or water conditioner that let go, a toilet that flooded two rooms, and roof leaks in monsoon storms. We handle the mold remediation, the water extraction and drying, and the drywall, flooring and cabinet repairs that finish the job.
FAQ
Gilbert Questions
My Gilbert house is fairly new. Can it still get mold?
Yes. Gilbert’s median home dates to 2003, but mold needs moisture, not age. EPA says materials dried 24 to 48 hours after a leak usually won’t grow it, and it recommends indoor humidity under 60 percent. A slow drip inside a wall often goes unnoticed until the smell shows up, which is why we open the wall instead of painting over a stain.
Does a Gilbert lot sit in a FEMA flood zone?
Check the parcel itself. FEMA’s maps for Gilbert, effective November 4, 2015, show Zones A, AE and AH plus shaded Zone X, and the town says flood water gathers beside canal and railroad embankments. Gilbert is NFIP community 040044, and its Development Services flood zone page offers an interactive map and flood zone determinations.
How hard is Gilbert's water?
About 10.79 grains per gallon on average in 2025, ranging from 6.61 to 17.54, according to the town’s annual water quality report. Gilbert’s water FAQ suggests setting a softener at 10 to 12 grains to cover seasonal swings. Scale collects in tanks and valves, so when a garage or laundry floor is wet we look at the water heater, the softener and the supply lines first.
Where is Tri Point Services based?
In south Gilbert, at 4218 S Ramona Street, ZIP 85297, close to the Queen Creek and San Tan Valley line. That is the address on our Google profile. Adam Kriloff, the owner, oversees every project, and the phone at (623) 288-5596 is answered at any hour.
Nearby
Which nearby towns does the Gilbert base cover?
All the towns around it. Queen Creek is next door to the east, about 6.6 road miles to its municipal complex on Ellsworth Road, and San Tan Valley lies beyond it in Pinal County. Chandler borders Gilbert to the southwest and Mesa to the north. See every town we serve.
Talk to our team
Musty smell or a spreading stain in your Gilbert home?
Call (623) 288-5596. Our base is on South Ramona Street, in south Gilbert.